OKC3S USMC BAYONET mounted on M&P15
OKC3S Marine Bayonet with Scabbard NSN: 1095-01-506-3424 * 8″ Blade * 13 1/4″ Overall * 1 3/8″ Wide * .200″ Thick Proprietary Carbon Steel * Clip Point – Full Tang Blade * 1 3/4″ Mission Serration * Phosphate non-reflective finish * 53-58 Rc. Hardness * Dynaflex® Handle ergonomically grooved to reduce hand fatigue with positioning access point for quick redirect of positioning of blade in reduced visibility situations. Scabbard * Manufactured with a low noise signature polyester elastomer * Fitted internal stainless steel spring friction device at throat of scabbard to secure bayonet * Ceramic-coated aluminum honing rod is located on back of scabbard * Equipped with two load bearing attaching straps with cross straps, which allows variations of placement on the load bearing equipment.
Video Rating: 4 / 5
I like your jeans
so its true then. the mp barrel is longer than the m4. thats why it doesnt fit right.
man where’d ya get those sick hanguards?
Might want to get a bayonet barrel adapter from Tacticool22; only thing I know of to make the bayonet fit properly since DPMS stopped making clamp on lugs. Don’t forget a new crush washer if you do!
damn, a barrel is too long….
Amazon has ‘em for 111.00
where did you get it?!?!
do u know where can i buy a Ceramic-coated aluminum honing rod
M-4, midlength handguard,heavy match barrel,55 grain ballistic tip. Thats my hog brush gun. This bayo will complete it for CQB.
is that eothech mounted on top of the rifle?
DAM!!! Thats a big ass knife!! (thats what she said)
I almost bought a M9 – until I saw this. Its great but I bought it for my Mossberg 590 SP and while it’ll fit most any M4/AR setup – the handle seems a bit longer than an my old M7 & the newer M9 and dosn’t fit over the mag end-cap cleanly. Actually slightly hangs over the edge about a 1/16th of an inch.
Currently loooking for a way to modify the 590 endcap or shim it to make for a better fit.
cool thanks
Weight, Knife: 14.5 oz.
Weight, Scabbard: 7.9 oz.
NSN: 1095-01-506-3424
Amazon.com says 1.45 pounds including Sheath
i think its the same width but its an inch and a half longer than the m4 barrel
ok, thanks for the tip
your fit issue is not due to barrel thickness, bayonets are designed for 20inch n 14.5inch only., 16inch no matter what u do will never get the slop out., unless u do what i did., use a surefire suppressor flashhider, the one with the birdcage that extends back over the barrel 2 inches, the bayonet will then sit on the flashhider like it was designed, thx for the vid, great knife
The problem is you have a civilian 16 inch barrel. If the bayonet was fitted on a military issue 14.5 inch barrel the ring would fit right on the nut behind the flash hider. The standard 20 inch barrel would be fine too because the sight radius is longer on an M16A2 or A4.
mines a parts gun bit the barrel is a fulton armory M4 style barrel
its a smith and wesson mp15 so now that i think about it im not sure if its a m4 style. might be a bit thinner
thinking about getting one for my AR and its an M4 barrel.
for sure
yes. fits a bit loose on the bayonets ring
that would suck nuts to get stabbed with that.